Sugar Land & Fort Bend County · Tankless water heater helpMon–Fri 7:00 AM–10:00 PM ET · Sat 8:00 AM–10:00 PM ET · Sun 7:00 AM–9:00 PM ET
Water dripping from a pipe connection under a wall-mounted tankless water heater
Home › Problems › Leaking Unit

Tankless Water Heater Leaking in Sugar Land, TX

Water under a tankless unit is a tracing job before it is a repair job. The water can come from a connection, a relief valve, the heat exchanger, or the condensate drain — and each one points to a different fix.

Call Now

Sugar Land & Fort Bend CountyWhat to check firstHow the diagnosis works

Need help with your tankless water heater?

Call Now to reach a local tankless water heater professional. Describe the unit, the symptoms, and any error code on the display.

Call Now

Hours: Mon–Fri 7:00 AM–10:00 PM ET · Sat 8:00 AM–10:00 PM ET · Sun 7:00 AM–9:00 PM ET

1
Describe the symptomsNo hot water, lukewarm water, an error code, a leak — the symptoms point to the cause.
2
Find the cause firstDiagnosis at the unit names the fault before any work starts.
3
Repair or replace, plainlyThe findings are explained in plain words, including when a repair makes sense and when it does not.
4
Tested at the tapsThe work is checked with hot water running at the taps before the visit ends.
Problem

What a leak looks like

A tankless leak shows up as water under the unit, damp on the wall behind it, a slow drip from a connection, or a wet patch on the floor that returns after mopping. The water may appear only when the unit runs, or it may be constant. It may be a slow weep that leaves mineral staining on the pipe below it, or a steady leak that pools on the floor. The pattern says where it comes from — and the tracing starts by watching it.

The first step is always the same: shut off the water to the unit at its isolation valves where it is safe to do so, and shut off the gas or power as well. Then mop up what you can, move anything the water can damage, and take a photo of the leak and the display. The water will tell its own story while you wait — where it comes from, how fast it comes, and whether it stops when the unit is isolated.

A leak that stops when the unit is isolated is coming from the unit. A leak that continues is coming from the house plumbing. That one observation, made before the visit, narrows the field by half.

The four sources, and how each one is found

Connections are the first source, and the easiest to find. The cold-water inlet, the hot-water outlet, the relief valve connection and the condensate connection are all joints, and each one can weep. The water appears below the joint, and the mineral staining on the pipe below it shows how long it has been weeping. The repair is to remake the joint.

The relief valve is the second source, and it needs a different kind of diagnosis. The valve is a safety device that opens when the pressure inside the unit gets too high, and a valve that weeps occasionally is doing its job. A valve that leaks constantly has either failed, or is responding to pressure trouble elsewhere. The pressure is measured, the valve is tested, and the house supply is checked.

The condensate drain is the third source, specific to condensing gas units. The drain carries acidic condensate away through a trap and a drain line, and when that line clogs — or freezes in a hard cold snap — the condensate backs up and leaks from the unit. The drain is checked for blockage and for a freeze-proof route.

The heat exchanger is the fourth source, and it is the one that changes the conversation. A leak from the heat exchanger itself usually means the unit has reached the end of its serviceable life, because the part is the bulk of the unit cost. Freeze damage is the local version: a heat exchanger cracked in the February 2021 freeze can leak months or years later.

Leaks after a freeze

A leak that appears after a hard freeze is a different diagnosis from a leak that appears on an ordinary day. The February 2021 freeze cracked heat exchangers, water lines and condensate drains across the Houston area, and a unit that was cracked then can leak now — when the weakened metal finally gives way, or when the next cold snap finishes the job.

A leak after a freeze is checked for freeze damage first: the heat exchanger, the water lines, and the condensate drain, in that order. The freeze check matters because it changes the recommendation. A connection leak after a freeze is a repair. A heat exchanger leak after a freeze is usually a replacement, because the crack is rarely the only weak point the cold left behind.

What to do while you wait

Shut off the water at the isolation valves and the gas or power where it is safe to do so. Move anything the water can damage, mop up what you can, and take a photo of the leak and the display. Note whether the leak stops when the unit is isolated, and whether it is worse when the unit runs.

Do not open the unit casing yourself. The gas, electrical and venting parts inside are not homeowner work, and a leak from the heat exchanger can be hot water under pressure. If the water has reached electrical outlets or the panel, stay clear and call.

What to do now

  • Shut off the water at the isolation valves where it is safe to do so.
  • Shut off the gas or power as well.
  • Move anything the water can damage, and mop up what you can.
  • Take a photo of the leak and the display.
  • Note whether the leak stops when the unit is isolated.
  • Do not open the unit casing yourself.

Call Now

Causes

What causes it

Loose connection

A joint that has worked loose with thermal expansion and contraction, weeping at the cold inlet or hot outlet.

Failed relief valve

A valve that has failed, or is responding to pressure trouble elsewhere in the system.

Blocked condensate drain

A trap or drain line clogged — or frozen — so condensate backs up and leaks from the unit.

Leaking heat exchanger

A coil leaking from the unit itself, usually meaning the end of its serviceable life.

Freeze damage

A heat exchanger, water line or drain cracked in a hard cold snap, leaking now or later.

Failed seal or gasket

A seal inside the unit that has hardened and failed with age and heat.

Signs

Signs of this problem

  • Water is pooling under or around the unit.
  • The wall behind the unit is damp or stained.
  • There is a slow drip from a connection, visible when the unit runs.
  • The relief valve pipe is wet, or water is coming from it constantly.
  • The floor near the unit is damp, with no other source in sight.
  • Mineral staining has appeared on the pipes below the unit.
  • The unit leaks more when it heats, and less when it is idle.
  • A leak appeared after a hard freeze or a cold night.

Related service: Tankless Water Heater Repair

Related guide: freeze protection guide

Related service: tankless water heater leak repair

Questions

Frequently asked questions

Questions people ask about leaking unit, answered plainly.

Shut off the water to the unit at its isolation valves where it is safe to do so, then shut off the gas or power as well. Move anything the water can damage, mop up what you can, and take a photo of the leak and the display. Do not open the unit casing yourself.

Follow the water: below a joint means a connection, at the relief valve pipe means the valve or the pressure, from the drain means the condensate line, and from the unit body means the heat exchanger. A leak that stops when the unit is isolated is coming from the unit.

It depends. A valve that weeps occasionally is doing its job. A valve that leaks constantly has either failed, or is responding to pressure trouble elsewhere. The pressure is measured and the valve is tested.

Usually not sensibly. The heat exchanger is the most expensive part of the unit, and fitting a new one into an old unit leaves every other worn part in place. A leaking heat exchanger usually means the unit has reached the end of its serviceable life.

A hard freeze can crack the heat exchanger, the water lines and the condensate drain. The February 2021 freeze did exactly that across the Houston area, and a unit cracked then can leak now, when the weakened metal finally gives way.

A condensing gas unit makes acidic condensate that drains away through a trap and a drain line. When that drain clogs — or freezes in a hard cold snap — the condensate backs up and leaks from the unit.

Yes — shut off the water at the isolation valves and the gas or power where it is safe to do so. A leaking unit that keeps running can make the damage worse.

It depends on the source. A connection, a valve or a drain is a repair. A heat exchanger leak is usually a replacement, because the part is the bulk of the unit cost. The tracing decides which one it is.

Dealing with this problem now?

Call Now to reach a local tankless water heater professional. Describe the unit, the symptoms, and any error code on the display.

Call Now

Contact

Call now for tankless water heater help

Tap Call Now to reach a local tankless water heater professional. Tell them the make of the unit if you know it, the symptoms, and any error code on the display.

Hours: Mon–Fri 7:00 AM–10:00 PM ET · Sat 8:00 AM–10:00 PM ET · Sun 7:00 AM–9:00 PM ET

Call Now

Before you call

  • Note the error code on the display, if one shows.
  • Check whether other taps have hot water, and whether cold water runs normally.
  • If the unit is leaking, shut off its water and gas or power where it is safe to do so.
  • Take a photo of the display and the label on the unit.
  • Note when the problem started and what changed just before it.
Sugar Land Tankless Pros — helper
☎ Call Now